Skip to main content

Vehicle profile & PowerSteer profile

The next step is to select or create a vehicle and enter the PowerSteer parameters. Then, the vehicle should be calibrated with the PowerSteer setup parameters for precise navigation.

  • Back to My equipment > Select vehicle.

  • If you do not have any vehicles listed, tap ADD VEHICLE +. In this flow, the app will create a vehicle
    and a PowerSteer profile.

  • If you have a saved vehicle, you can use it > tap Select vehicle, then tap ADD POWERSTEER PROFILE +

You need to enter the following information about the vehicle:

  • Vehicle type.
  • Brand and Model.
  • Name is not required. If you do not provide a name, the App will automatically generate one from the brand and model.

  • Wheelbase: The distance between the centers of the front and rear wheels.

  • Rear axle: The distance between the centers of the two rear tires.

  • Wheel angle (max): The maximum angle of turn for both the left and right wheels from the center, entered in degrees. The average angle should be filled.

image.png





Then configure the PowerSteer Controller by adding the necessary parameters.

PowerSteer Profile

If you have saved a vehicle, you can use it > tap ADD POWERSTEER PROFILE +

Choose the location where you want to install the PowerSteer Controller:

  • On the bonnet (hood);

  • On the roof.

Then, you can enter the Controller settings:

  • Position Height: The height from the ground to the bottom of the controller. It should be between 1 cm and 600 cm. 
  • Left/Right Offset: The distance from the tractor's centerline to the controller. It should be between 0 cm and 300 cm.
  • Front Offset: The distance from the center of the rear axle to the center of the controller. It should be between 25 cm and 1000 cm. 

We recommend setting the controller at a minimum Front offset 80 cm.

Roof installation
Screenshot_20250317_163923_FieldBee.jpg Screenshot_20250317_163937_FieldBee.jpg Screenshot_20250317_163959_FieldBee.jpg
Bonnet installation
Screenshot_20250317_164214_FieldBee.jpg Screenshot_20250317_164223_FieldBee.jpg Screenshot_20250317_164243_FieldBee.jpg

Review the Summary of Measurements. If necessary, you can tap on a parameter, and the app will return to the selected parameter.

Named PowerSteer profile and set to controller.

Screenshot_20250317_164113_FieldBee.jpg Screenshot_20250317_164133_FieldBee.jpg Screenshot_20250317_164142_FieldBee.jpg

Then go to My equipment.

Next step Calibration Vehicle and PowerSteer profiel.

Version Action Editor Comments
v4. 18032025 updated Yevheniia Bohatyrova