Skip to main content

Vehicle profile & PowerGuide profile (from v.10.7.1)

Vehicle profile & PowerGuide profile

The next step is to select or create a vehicle and enter your vehicle parameters. Then, tilt calibration should be performed.

Note: Vehicle profile and tilt calibration is optional for PowerGuide. Vehicle profile and tilt calibration is used only for tilt compensation functionality.

image.png

image.png

You need to enter the following information about the vehicle:

  • Vehicle type.

  • Brand and Model.

  • Name is not required. If you do not provide a name, the App will automatically generate one from the brand and model.

  • Wheelbase: The distance between the centers of the front and rear wheels.

  • Rear axle: The distance between the centers of the two rear tires.

  • Wheel angle (max): The maximum angle of turn for both the left and right wheels from the center, entered in degrees. The average angle should be filled.

image.png

image.png

image.png

image.png

Then configure the PowerGuide Controller by adding the necessary parameters.

PowerSteer Profile

If you have saved a vehicle, you can use it > tap ADD POWERSTEER PROFILE +

image.png

Choose the location where you want to install the PowerSteer Controller:

  • On the bonnet (hood);

  • On the roof.

image.png

Then, you can enter the Controller settings:

  • Position Height: The height from the ground to the bottom of the controller. It should be between 1 cm and 600 cm. 
  • Left/Right Offset: The distance from the tractor's centerline to the controller. It should be between 0 cm and 300 cm.
  • Front Offset: The distance from the center of the rear axle to the center of the controller. It should be between 25 cm and 1000 cm. 
    Roof installation
    Screenshot_20250317_163923_FieldBee.jpg Screenshot_20250317_163937_FieldBee.jpg Screenshot_20250317_163959_FieldBee.jpg
    Bonnet installation
    Screenshot_20250317_164214_FieldBee.jpg Screenshot_20250317_164223_FieldBee.jpg Screenshot_20250317_164243_FieldBee.jpg

    Review the Summary of Measurements. If necessary, you can tap on a parameter, and the app will return to the selected parameter.

    Named PowerSteer profile and set to controller.

    Screenshot_20250317_164113_FieldBee.jpg Screenshot_20250317_164133_FieldBee.jpg Screenshot_20250317_164142_FieldBee.jpg

    Then go to My equipment.

    Next step Tilt Calibration Vehicle and PowerSteer profile.

    No Comments
    Back to top