Starting and Synchronizing Tasks (10.10.x)

Before you begin field operations, ensure both systems are properly configured and synchronized to enable precise implement control.

1. Pre-Operation Checklist

Before starting the Jaltest app, you must complete these preparation steps in the FieldBee application:

• Add Vehicle Parameters:

  • Measure and enter the distance from the rear axle to the 3-point hitch.

  • Measure and enter the distance from the rear axle to the drawbar or towed hitch.

• Field Setup: Ensure you have already created the field where you intend to work.

2. Active work with Jaltest app

After activation Connection with Jaltest ITC from settings. 

1. Go to Navigation: appears Jaltest ITC connection widjet.
2. Then Home on Tablet and open Jaltest ITC application. 
3. When Jaltest ITC opened, in Navigation Jaltest ITC widjet shows as connected.

Creating a New Task and automatic syncronization between applications

Once your vehicle parameters are set and Jaltest communication is enabled, follow these steps to start a task:

1. Open Navigation: In the FieldBee app, tap the Add (+) button to create a new task.

2. Select Task Type: Choose your operation (e.g., Tilling, Spraying, Fertilizing, or Planting).

3. Select Field and Vehicle:

   • Choose the required Field for the operation.  The field automatically synchronize to Jaltest app

   • Choose the Vehicle profile (e.g., Case 5130) previously configured. the vechicle automatically synchronize to Jaltest app.

   • ISOBUS implement automatically synchronized from Jaltest to Fieldbee app.

4. Navigation

1. Tap the Start (Yellow Arrow) button in FieldBee to begin navigation.

2. Active Tracking: Once started, track recording begins simultaneously in both applications, allowing you to monitor navigation in FieldBee while managing implement data in Jaltest.