PowerSteer. Search and establish a connection.

Connecting to the receiver and autosteer.

For general information about connecting receivers and autosteer controllers, please refer to the
"Connecting to the receiver and autosteer basics" section.

Information!
Further in this section, only the connection steps specific to the PowerSteer autosteer system are described.

PowerWheel. Check the connection 

The PowerSteer Controller establishes a connection with the PowerWheel using a harness. 

• Press CONNECT TO POWER WHEEL to initiate the connection verification process.

• The PowerWheel connection has been established successfully. 

Now, tap CONNECT TO RTK to proceed and configure the NTRIP/Base Station connection.

RTK Setup

To configure corrections, you must establish a connection with either a local NTRIP provider or set up a connection with a Base Station. Please refer to the "RTK Setup" section.

Connection Successful

On the Connection Successful activity, you can review the connection diagram and confirm that all statuses are connected on the left side.

The next step is to select or create a vehicle and enter the PowerSteer parameter. 

Systems Safety

Warning!
Do not use guidance systems on the roads. Always turn off the guidance system before entering the roadway.

Warning! 
Do not attempt to enable (activate) the guidance system during transportation on the roadway.

Warning! 
Guidance systems are designed to assist the operator in performing field operations more efficiently. 

Warning!
The operator is always responsible for the path of the vehicle. 

Warning!
Systems do not automatically detect or prevent collisions with obstacles or other vehicles.