Install Jaltest App and Post-Update Configuration

Updating your Jaltest ISOBUS software ensures you have the latest features, bug fixes, and compatibility improvements. Follow these steps to transition from version 25.2.0.3 to the latest release.

Prerequisites Jaltest app

• Open Jaltest app. At bottom bar find Settings icon and tap it.

• Tap I About... icon, then check the version: 25.2.0.3

• Internet Connection: Ensure your device is connected to a stable Wi-Fi or mobile data network.

Update Instructions

1. Visit the FieldBee Download Page Open your web browser and navigate to the official FieldBee application page: https://www.fieldbee.com/app

2. Download the New Version

Find the button: Jaltest ISOBUS. Tap it button, then download link. 

Note: Depending on your browser settings, you may see a prompt asking for permission to download files from this site. Tap Allow or Download.

3. Initiate Installation Once the download is complete, a notification will appear at the top of your screen or within your browser's download manager. Tap Open to begin the installation process.

4. Confirm the Update If prompted by your device's security settings, select Install.

The system will overwrite the old version (25.2.0.3) with the new software while keeping your settings intact.

 

 

 

 

 

Instal or Post-Update Configuration: Jaltest ISOBUS nav app

After installation or updating of Jaltest app, follow these steps to activate your license and ensure the Fieldbee Controller communicates correctly.  Configurate and find additional info about Jaltest, you can in Settings of application.

• Once at year, but one month in advance,  customer will be notified that they need to connect to our servers  for mandatory security reasons.

1. Disable Jaltest Wi-Fi connection  

FieldBee configuration reuires connect  I-Connect by USB-C cable.
To avoid conflict Wi-Fi of I-connect must be disabled.

• Go to Settings.

• Select JALTEST I-CONNECT.

• Switch Wi-Fi to OFF 

2. Power Connection & License Verification

Before configuring the software, ensure the hardware is powered and all necessary software modules are unlocked.

• Power On: Ensure the ISOBUS implement is fully powered and connected.

• License Check: Navigate to Settings and verify that the following licenses are active:

  • GV-PRO

  • UT (Universal Terminal)

  • TC-SC (Task Controller Section Control)

Troubleshooting Licenses: If any of the above modules are not activated:

• 1. Go to Settings > ISOBUS Web Services.

  2. Check the Connection Status to ensure the terminal can reach the server.

  3. Verify all physical cable connections.

  4. Refresh the license status.

If the licenses remain inactive after these checks, please contact the Support Team for assistance.

3. Fieldbee Controller Communication

Set the GNSS antenna to communicate via the CAN bus (USB-C) for stable data transmission.

• Navigate to Settings > Antenna Adjustment.

• Select Antenna Communication.

• Choose CAN.

4. GPS & Guidance Configuration

Finally, configure how the system interprets positioning and speed data.

• In Settings > Antenna Adjustment, select GPS Data Configuration.

• Open the GPS Data tab and apply the following settings:

  • Speed: Set to GPS.

  • Guidance: Set to GPS.

5. Final Connection Status Check

Once all parameters are saved, navigate to the Navigation Screen. Look at the status bar on the left side for a quick diagnostic overview:

• ISOBUS Connection: Confirms the implement is communicating with the terminal.

• CAN Connection: Verifies the data link between the Fieldbee Controller and the Jaltest unit.

• Satellites: Displays GNSS signal strength and positioning accuracy.

• First Implement connection event could take even 5 minutes to be completed.

 

So, now you can go and start to work with Fieldbee application.