FieldBee Base Station in Radio mode

The FieldBee base station can work in different correction data output modes — one of them is Radio mode.

In Radio mode, the base station sends RTK correction data directly over a radio signal instead of the internet.
The rover (FieldBee receiver in your tractor) picks up those corrections through its built-in radio link.

To configure a FieldBee base station radio mode, you need to use the Toolbox App.

(Latest version of the FieldBee Toolbox App)

Warning!
Before switching your controller to radio mode, please ensure that the radio antenna is securely screwed into its place.

To connect to the Fieldbee Base Station in radio mode, during RTK Setup, select the corresponding NTRIP Source:

Tap CONTINUE after selecting the correction source.

On the base station connection screen, enter Base Station ID or SCAN QR CODE from the Base Station.

Information!
Record and save your Base Station ID, You can find it at the back of the Base Station.

Wait until the connection is established:

Upon a successful connection to the correction source provider, a "Success" message will be displayed, and shortly after, RTK corrections should appear.

Tap on the SAVE button to finish and save changes.