FieldBee Base Station in NTRIP mode.

The FieldBee base station can work in different correction data output modes — one of them is NTRIP.

NTRIP is a protocol that streams RTK correction data over the internet instead of radio. This allows you to use RTK corrections even outside the range of local radio communication — as long as there is mobile internet.

To configure a FieldBee base station for NTRIP mode and set up the network connection, you need to use the Toolbox App.

(Latest version of the FieldBee Toolbox App)

Information
Record and save your Base Station ID, you can find it at back of Base Station.

To connect to the Fieldbee Base Station NTRIP, during RTK Setup, select the corresponding NTRIP Source:

Tap CONTINUE after selecting the NTRIP source.

On the base station connection screen, enter Base Station ID or SCAN QR CODE from the Base Station.

Wait until the connection is established:

Upon a successful connection to the NTRIP provider, a "Success" message will be displayed, the NTRIP status will change to Connected, and shortly after, RTK corrections should appear.

Tap on the SAVE button to finish and save changes.

Information!
By default, some Fieldbee Controllers can be connected to the FieldBee Base Station (42C20000).