Autosteer connection type

Connecting to the autosteer.

For general information about connecting receivers and autosteer controllers, please refer to the
"Connecting to the receiver and autosteer basics" section.

Information!
Further in this section, only the connection steps specific to the ECU-S1 Autosteer autosteer system are described.

Autosteer connection type

Select your connection type beetween application and the ECU-S1 Autosteer controller from the list. 

There are three types of connections to the ECU-S1 Autosteer controller are available to choose:

• Select Wi-Fi Router connection beetween application and AutoSteer in case if your ECU-S1 is connected with Ethernet cable to the Wi-Fi router. (Mobile device should be connected to the router’s Wi-Fi network *rtkwifi by default);

Information
Mobile device with application should be connected to the router’s Wi-Fi network, named rtkwifi by default.

• Select Wi-Fi connection beetween application and AutoSteer in case of direct connection to the ECU via Wi-Fi network (Wi-Fi should be enabled on your mobile device);
  

Information
Wi-Fi should be enabled on your mobile device.

• Select Ethernet connection between the App and Autosteer in case of direct connection to the ECU with Ethernet cable.
  

Information
Ethernet cable should be connected to your mobile device.

After selecting your connection type click CONTINUE.

Connection Diagrams with connection type specific instructions are displayed, outlining the connection process for each connection type:

• Make sure the ECU-S1 Controller is turned on and ready for connection.
  
• Check components connection accordingly to displayed connection diagram.
• Complete connection type specific instructions displayed on connection diagram.

Tap CONTINUE.